Menu path
Mod-Roof > Slice-Hip
𧰠What Slice-Hip does
Slice-Hip lets you lop off a portion of a hip end or remove a whole long side of a roof.
đ When youâd use it
This is typically used when a roof needs to abut an adjoining property boundary or a shared wall.
đŞ How to use Slice-Hip
Go to Mod-Roof > Slice-Hip.
When prompted, locate/select the eave line you want to slice relative to.
Enter a âStationâ value.
đ What âStationâ means
The Station is the position where you want the hip sliced, measured horizontally from the selected eave line.
â ď¸ Important limitation
You can only slice a hip end if it is defined as an eave that has a hip at each corner.
𧞠What changes after slicing (line types)
By default, the two new raked flashing lines created by Slice-Hip are assigned as Eave.
If you need different flashing/line types, you can change them any time using Tools > Cha-LineType.
đĄ Remember: Use Tools > Cha-LineType for more control over the flashing used on the new geometry.
đźď¸ Examples
Example 1: Right-hand hip sliced â Same affect as the Lay-Back Gable command.
BEFORE AFTER
â
Example 2: Bottom plane modified - Not suitable for Lay-back Gable command.
BEFORE AFTER
â